IDeal Intelligent Technology Co., Ltd.  

Product Name: 2020 New Famous Barrier Radar Sensor/Traffic Detector with Anti-Hit and Trigger Function for Parking Model NO.: IDL-VBR10 Voltage: 220V Certification: CE Design: Single Post The Vehicle Inlet and Outlet: Center Falling Prevention Device: Pull-Type Driving: Positive Operation Working Mode: Anti-Smash and Trigger Type: Parking Sensor Name: Barrier Radar Sensor Trademark: IDL Transport Package: Standard Neutral Package or Customers Requirement Origin: China HS Code: 847190 Product Description Technical Parameters1) Input Voltage: DC12V 150mA2) Working Frequency: 24-24.5GHz3) Modulation Mode: FMCW4) Sending Power: 10-15dBm5) Angle between the Beam and Pole: Wide wave<15°, Narrow wave<12°6) Detection Distance: 1 - 6 meters, ±0.2 meters7) Communication Method: RS485, Baud Rate 1152008) Working Temperature: -40ºC~+85ºC9) Protection Level: IP6710) Dimension(L*W*H): 131mm*106mm*28.5mmAre you still troubled to install loop detector and loops? 1) Cutting ground-Waste time and not good looking; 2) Complex wiring-Messy and Difficult; 3) Mud road-Cannot fix the loop; 4) Cannot detect big truck, trailer or other vehicles with high-bed.Why choose barrier radar detector? 1) Can replace loop detector completely; no wiring layout, save time and cost. 2) Easy installation; Easy parameters setting; Adjustable distance from 1 to 6m. 3) Work in range of 24-24.5Ghz without effects from any climatic environment. 4) Can effectively distinguish vehicles and humans to avoid any hitting. 5) Can be used for trigger detection, e.g. trigger camera to capture the picture. 6) Can be used to trigger the alarm in the warning zone. 7) Can record the traffic and no data is lost when power is off.Radar Detector Installation 1) The trigger radar and the anti-smash radar should be installed perpendicular to the lane's direction. The anti-smash radar is installed on the cabinet below the barrier pole. The trigger radar is installed on the special bracket for the radar installation. The optimal height from the ground to the radar center is 0.6 meters. 2) The barrier's cabinet must be fixed firmly to avoid shaking when the barrier is working. 3) Within the detection area, there should be no obstacles other than the barrier pole, e.g. traffic cones, isolation bars, signs, etc.. 4) Please update the radar background in time after the environment in the detecting area is changed.( The above picture's ratio is 10:1. The lane width is 3 meters and the trigger distance is 4 meters) 5)Anti-smash Radar Detector Installation DiagramWiring DefinitionColorDefinitionRedPower Input +12VDCBlackPower Input GNDBlueRS485+GreenRS485-GreyFunction Switch InputBrownFunction Switch Input GroundWhiteRelay Output NOYellowRelay Output COMRadar Antenna HFSS Simulation Effect As shown in the above figure, the radar detector can be installed laterally to obtain a narrow beam.